Everything you never wanted to know about working on your MkV VW.

DIY: replacing shift bracket bushings

June 3rd, 2009 Posted in 2.0T FSI, 2.5L, Jetta/GLI, Rabbit/GTI

Tools:
Socket wrench
10mm socket
13mm socket
T25 torx
flathead screwdriver

Step 1: Remove intake (and/or engine cover depending on how your car is equipped).

Step 2: Remove battery. Disconnect negative terminal, then positive. Then remove 13mm bolt and clamp holding battery in place. Remove battery and sides of battery box, set aside.





Step 3: Remove 3 10mm bolts holding battery tray in place. Remove battery tray and set aside.



Step 4: Remove clips holding shift cables to relay levers. Slide cables off relay levers.


Step 5: Remove clips holding shift cables to the bracket.

Step 6: Remove 2 10mm bolts and 1 10mm nut holding shift bracket to the transmission.

Step 7: Slide the bracket further up the cables to get a little room to work.

Step 8: Take the metal piece out of each bushing.

Step 9: Remove rubber bushings.

Step 10: Install the new metal bushings, and bolt the bracket back in place.





Remainder of install is reverse of removal. Be sure to re-install all the clips that secure the shift cables (2 clips at the bracket, 1 clip on each cable end).

You must be logged in to post a comment.